(Contact : physiola@hanmail.net , Buy : Amazon PhysioLab)
PSL-iEOG2 is a small 2-channel EOG module that outputs EOG and EOG Direction Event signals.
DC 5V input power can be used the power of the Arduino board without any other power supply which is very convenient. Amplification is a 750 V/V. The notch filter can be adjusted to 50Hz or 60Hz by the notch filter selectable switch. The module outputs a high-quality EOG signal by applying the low noise and optimal filter design.
PSL-iEOG2 guarantees electrical safety through isolation power and signal during measuring. For the high quality signal input the premium lead cable with shield is provided, and the cable adopts a stereo jack to connect simply.
Main Features
- Analog EOG 2-channel amplifier module(Ch.1 EOG, Ch.2 EOG Direction Event)
- DC 5V power input
- Isolation power and signal
- Amplification 750V/V
- Selectable 50Hz or 60Hz by the notch filter switch
- Size 56mm x 35mm
- Lead cable with shield and stereo jack
Block Diagram
Item
|
Spec.
| |
Output signal
|
EOG, EOG Direction Event(2 channel)
| |
Output signal range
|
0~3.3V(Center 1.65V)
| |
Electric current consumption
|
below 50mA
| |
Amplification
|
750V/V(below ±2%)
| |
Filter set
|
Notch
|
Adjustable 50Hz or 60Hz
|
HPF
|
0.05Hz
| |
LPF
|
10Hz
| |
Isolation
|
Power & Signal
| |
Insulation Withstand Voltage
|
1kV DC(5sec.)
| |
Size
|
56mm x 35mm(PCB)
| |
CMRR
|
60dB
| |
Contents
| -PSL-iEOG2 module 1EA -3 wire shielded lead cable (1,100mm, stereo jack) 1EA -Output Cable 1EA -Electrode 1Pack (6ea) -Manual 1EA | |
Application
PSL-iEOG2 & PSL-DAQ
PSL-iEOG2 & Arduino UNO
댓글 없음:
댓글 쓰기